Difference between revisions of "FPGA Controller PC-Board"

From ATI public wiki
Jump to: navigation, search
(Created page with " =Important improvements= *Controllable power outlets: One of the important aspects of remote labs in general is to guarantee the safety of the instruments under use. One of t...")
 
m
 
(3 intermediate revisions by the same user not shown)
Line 1: Line 1:
 
=Important improvements=
 
*Controllable power outlets: One of the important aspects of remote labs in general is to guarantee the safety of the instruments under use. One of these safety points is control over power lines of the boards while the user is not using the service. Hence, we need to add controllable power outlet through the server.
 
 
 
=Schematics and PCB files=
 
=Schematics and PCB files=
You can find the schematics and PCB files for this version here:
+
[[File:Screen Shot 2015-05-18 at 12.44.01.png|400px|right]]
* Schematic file
+
[[File:Screen Shot 2015-05-18 at 12.44.20.png|400px|right]]
* PCB file
+
You can find the schematics and PCB files for this version in the [https://github.com/siavooshpayandehazad/TTU_ElevatorLab/tree/master/SchematicsAndPCB GIT repository for PCB files].
 +
Here are some updates from the previous version:
 +
* The Safety-Monitoring system can check all the sensors and monitor the behaviour of the lift more carefully.
 +
* On-Board seven-segment display has been removed. Each floor has a separate seven segment.
 +
* Heat-sink was added to the regulator IC

Latest revision as of 09:25, 21 May 2015

Schematics and PCB files

Screen Shot 2015-05-18 at 12.44.01.png
Screen Shot 2015-05-18 at 12.44.20.png

You can find the schematics and PCB files for this version in the GIT repository for PCB files. Here are some updates from the previous version:

  • The Safety-Monitoring system can check all the sensors and monitor the behaviour of the lift more carefully.
  • On-Board seven-segment display has been removed. Each floor has a separate seven segment.
  • Heat-sink was added to the regulator IC